Kopex Thread Converter, Conduit Fitting, 20mm Nominal Size, 1/2 Inch NPT → M20, Brass
Tekninen dokumentti
Tekniset tiedot
Merkki
KopexNominal Size
20mm
Fitting Type
Thread Converter
Thread Size
1/2 Inch NPT → M20
Material
Brass
IP Rating
IP66
Series
EX/TC
Alkuperämaa
United Kingdom
Tuotetiedot
Thread Converters
A range of Kopex brass fittings which provide a method of matching thread forms on hazardous area approved equipment whilst ensuring the integrity and Ex approval of the installation is maintained. These thread converters meet the latest ATEX/IECEx standards and have them clearly marked on the main body of the product, allowing them to be seen easily once installed, a key component of the new standard.,Enlargers (/E) are used where the thread size of the female side of the device is larger than the male side.,Reducers (/R) are used where the thread size of the female side of the device is smaller than the male side.,Adapters (/TC) are used where a conversion is required between thread types e.g. Metric to PG.
Approvals
ATEX Certification. BASEEFA07 ATEX 0247X, IECEx Certification. IECEx BAS07.0090X.
Kopex Ex-System
Varastotiedot eivät ole tilapäisesti saatavilla.
Tarkista myöhemmin uudelleen.
€ 9,00
1 kpl (5 kpl/pakkaus) (ilman ALV)
€ 11,16
1 kpl (5 kpl/pakkaus) (Sis ALV:n)
5
€ 9,00
1 kpl (5 kpl/pakkaus) (ilman ALV)
€ 11,16
1 kpl (5 kpl/pakkaus) (Sis ALV:n)
5
Osta irtotavarana
| Määrä | Yksikköhinta | Per Pakkaus |
|---|---|---|
| 5 - 45 | € 9,00 | € 45,00 |
| 50 - 245 | € 8,50 | € 42,50 |
| 250+ | € 8,10 | € 40,50 |
Tekninen dokumentti
Tekniset tiedot
Merkki
KopexNominal Size
20mm
Fitting Type
Thread Converter
Thread Size
1/2 Inch NPT → M20
Material
Brass
IP Rating
IP66
Series
EX/TC
Alkuperämaa
United Kingdom
Tuotetiedot
Thread Converters
A range of Kopex brass fittings which provide a method of matching thread forms on hazardous area approved equipment whilst ensuring the integrity and Ex approval of the installation is maintained. These thread converters meet the latest ATEX/IECEx standards and have them clearly marked on the main body of the product, allowing them to be seen easily once installed, a key component of the new standard.,Enlargers (/E) are used where the thread size of the female side of the device is larger than the male side.,Reducers (/R) are used where the thread size of the female side of the device is smaller than the male side.,Adapters (/TC) are used where a conversion is required between thread types e.g. Metric to PG.
Approvals
ATEX Certification. BASEEFA07 ATEX 0247X, IECEx Certification. IECEx BAS07.0090X.